Versatile On/Off Magnet-Base Shields |
|||||||||
|
|||||||||
|
These versatile On/Off magnet-base shields can be used on lathes, drills, mills, grinders, or any equipment that has a flat, ferrous mounting surface. The heavy-duty magnetic base is 2 3/4" square with a V-groove and measures 3" high. The 200-lb holding force keeps the shield in place when the magnet is on. If an adequate flat, ferrous mounting surface is not available, an optional steel mounting plate (Part No. FKT-1106; see below) can be permanently attached to the machine to hold the magnetic base. The 12", 18", and 24" flexible arms are made of spring steel and are covered with vinyl to protect them from grease, oil, and contaminants that would weaken their holding power. They offer virtually unlimited adjustment possibilities and have long-term holding power. The transparent portion of these shields is constructed of high-impact-resistant, 3/16"-thick clear polycarbonate. The shield places a barrier between an operator and the flying chips (swarf), sparks, and coolant generated at the point of operation. A variety of flat, angled, and concave shields are available. |
|||||||||
|
|
|||||||||
|
|||||||||
|
Replacement Shields Only
|
|||||||||
Replacement Flexible Arm Only
|
|||||||||
|
|||||||||
|
On/Off Magnetic-Base Only
|
|||||||||
|
|||||||||
 |
|||||||||
Replacement Knob and Optional Mounting Plate
|
The products and photos on this site are carefully checked for accuracy; however some cosmetic differences may occur.
